Use a layer to a right to join the measurement marks made in steps 1 and 2 to form a rectangle or square in the ceiling plate edge. He came through the layout of the ceiling plate with a knife, with an edge level recto. Lift up red. Center tile in the opening beneath the duct opening and lessen the tile in place. Instead of opening heat register through the hole in the ceiling plate and the opening of registration coverage conduit. Board heat should partially cover the surface of the tile, which hides imperfections made when the hole is cut. Tips & Warnings: Install all 2×2 drop ceiling tiles with hot air ducts before installing full tiles. If you have round duct, determine the fundamental location of the duct opening in the ceiling grid and transfer this to the plate ceiling.
2×2 drop ceiling tiles – A false ceiling or fall is made up of new ceiling tiles applied on an additional ceiling. Once installed, the tiles fall from the ceiling height by a few meters or a few centimeters. Sometimes the pieces are installed to hide a new heating system or electrical elements. The tiles used on the ceiling are usually gray or white and are not too attractive. Ideas ugly dropped ceiling tiles include hidden these tiles away for your roof look much better.
When installing 2×2 drop ceiling tiles in the basement, along with forced air heating and cooling ducts extending along the rafters and pushes the air into the room through the configuration it requires ceiling. This heat registers can be mounted on a plate ceiling. La difficult part of this project is not installing the log, but the hole is cut placement. He for registration should be centered under the opening of the conduit for the record for fit within the duct and hides the hole in the tile.
Instructions: Measured from the edge of the ceiling grid opening the front edge of the opening conduit. Transfers this measure to a ceiling plate, sitting face up on a hard. Make sure surface you measured the edge of the roof plate that will be sitting on the front edge of the grill. Measure from the edge of the opening left grid ceiling left edge of the opening conduit. Transfers this measurement to the same ceiling plate, the measurement of what will be the left edge of this plate 2×2 drop ceiling tiles. Repeat step the ideal edge and the trailing edge.